Cells were resuspended in 15 ml of the same buffer, and fatty acids and their respective methyl esters (Sigma, St. Louis, MO, USA) were added to the cell suspension to a final concentration of 50 μg ml-1. Stock solutions (1 mg ml-1) of fatty acids and methyl esters were prepared immediately before

use by sonication for 4 min in anaerobic potassium phosphate buffer (100 mM, selleck pH 7.0, containing 1 mM DTT). Untreated and heat-treated cells (100°C for 20 min) served as control samples. Following 30 min incubation of cell suspensions with fatty acids, cell integrity was measured using PI. Ten μl of each sample were added to 985 μl of anaerobic potassium phosphate buffer, to which was added 5 μl of 1.5 mM PI (prepared in distilled water and stored at 4°C in the dark). The mixtures were incubated for 15 min at 39°C in the anaerobic chamber, then transferred to an ice-water slurry and kept in the dark find more for up to 45 min before being analysed for fluorescence using a fluorimeter or by flow cytometry. Fluorimetry

measurements were made using a spectrofluorimeter set at λEX = 488 nm and λEM = 650 nm. Flow cytometry was carried out with a FACSCalibur flow cytometer (Becton Dickinson Immunocytometry SCH727965 molecular weight Systems, San Jose, California, USA) equipped with an air-cooled argon ion laser emitting 15 mW of blue light at 488 nm. The red fluorescence of the PI signal was collected in the FL3 channel (>600 nm long-pass filter). FACSFlow solution (Becton Dickinson) was used as sheath fluid. The analyses were done using the low rate settings (12 μl/min). ATP and acyl CoA pools The influence of LA on metabolic pools in B. fibrisolvens was measured in cells growing in Roché et al. [45] medium in the anaerobic chamber, as follows. Fresh overnight culture (60 ml) of B. fibrisolvens

JW11 was mixed with 60 ml of uninoculated medium, or uninoculated medium containing 200 μg LA ml-1, then samples (3.0 ml) were taken periodically into 1 ml of 30% (w/v) perchloric acid. After 10 min, 4 ml of KOH were added to the acidic solution, forming a precipitate of potassium perchlorate, which was removed by centrifugation Sitaxentan (15,000 g, 15 min, 4°C). The supernatant was stored at -80°C, then subsequently thawed and ATP was measured using a luciferase preparation according to the manufacturer’s (Sigma) instructions. Acyl CoA measurements were made in parallel 120-ml control or LA-containing cultures after 20 min incubation. Cultures were maintained under CO2 and centrifuged immediately at 15,000 g for 15 min at 39°C. The pellet was stored in liquid nitrogen. Derivatization, separation, and fluorescence detection of acyl CoAs were carried out as described by Larson and Graham [46]. Identification of acyl CoAs was carried out using mass spectrometric analysis of peaks obtained from a Hypercarb porous graphitic carbon column [47]. Bacterial protein was measured by a modification of the Lowry method [48].