“The use of tandem mass spectrometry (MS/MS) for screening


“The use of tandem mass spectrometry (MS/MS) for screening of inherited metabolic disease in newborns has afforded many unique opportunities in the understanding of the benefits early their early detection, diagnosis and treatment. From the standpoint of the laboratory and modern analytical

methods, the use of MS based analysis demonstrated that a multiple metabolite-multiple disease screen-one method approach expanded screening significantly. MS/MS and SB202190 supplier newborn screening has served as a model of one type of approach in preventative health care that has shown proven benefits. It has been nearly 20 years since the introduction of MS/MS analysis of dried blood spots from newborns. There have been many lessons learned in both the analytical approach as well as

follow-up at the BKM120 inhibitor bedside. These lessons can be applied to future applications of MS/MS in newborn screening as well as other areas of metabolism and metabolic profiles such as that from acquired disease, environmental disease and other factors such as nutrition and age. The use of a highly specific, sensitive and multiplex platform such as MS/MS will continue to grow and experience in the newborn screening application will insure this outcome.”
“For the first time, the complex composition of a two-reactor-produced impact polypropylene copolymer (IPC) has been fully revealed by advanced thermal analysis, using the combination of fast scanning DSC (HPer DSC, flash DSC, and solution DSC) with SEC fractionation subsequent to TREF fractionation. The dual TREF-SEC separation provided fractions of a few micro- or nanograms that were used to correlate the molecular structure of the polymer chains and their thermal properties (melting and crystallization behavior of the different macromolecules under a variety of different conditions). The SEC fractions were collected using the LC transform Vactosertib concentration interface and subjected to FTIR and fast scanning DSC analysis. The SEC curves showed mono-, bi-, and multimodal molar mass distributions. The

SEC fractions collected were analyzed by HPer DSC at 50 degrees C/min by which the thermal properties of the fractions could be established and salient details revealed. The findings were confirmed by structural information that was obtained using FTIR measurements. These results confirmed that even after TREF fractions were obtained they were complex regarding molar mass and chemical composition. By applying HPer DSC at scan rates of 5-200 degrees C/min and flash DSC at scan rates of 10-1000 degrees C/s, the metastability of one of the fractions was studied in detail. The high molar mass part of the material appeared to be constituted of both highly isotactic PP and low to medium propylene content ethylene copolymers (EPC). The medium molar mass part consisted of high to medium isotactic PP and of low propylene content EPC. The low molar mass part did not show ethylene crystallinity; only propylene crystallinity of medium to low isotacticity was found.

Comments are closed.