This is due to the fact that in shallow water regions the presence of the surge influences the tidal distribution through the bottom friction and non-linear momentum advection terms (Horsburgh and Wilson, 2007, Jones and Davies, 2008a and Xing et al., 2011). The statistics of the final set of model results for all 25 tide gauge sites and for principal diurnal and semi-diurnal constituents are reported in Table 1 and in Fig. 3. A satisfactory agreement between the computed and empirical tidal constituents is found. The average vectorial difference is lower than 1 cm for all constituents except for the K1 diurnal tidal wave. The highest differences are found in the Northern Adriatic Sea, which is one

of the areas with maximum tidal amplitude in the whole Mediterranean Sea. The Kassandra

model performance was compared with existing tidal models for the Mediterranean Sea. The selected ZD1839 in vitro tidal models used in this study, and for which results are available, are the following: • the two-dimensional hydrodynamic model of Tsimplis et al. (1995) which is forced by the equilibrium tide and the incoming tide at the Strait of Gibraltar. The model has a regular resolution of 1/12°° and considers the M2, S2, K1, and O1 tidal constituents. Inspection of Table 2 indicates that along the Italian EPZ015666 order peninsula and for the period considered the Kassandra modelling system (RSS = 1.46 cm) has performed better than both the hydrodynamic model of Tsimplis et

al. (1995) (RSS = 2.18 cm) and the assimilation based model (Table 3 in Arabelos et al. (2010)) (RSS  = 2.00 cm). In order to investigate the effect of wave-current interactions, the model results are compared to those obtained from the same system without considering the interactions between the tide, wave and surge (uncoupled version). Analysis of simulation results are presented in terms of the difference between the average of observed and simulated values (BIAS), centred root mean square about error (CRMS), correlation coefficient (Corr) and Scatter Index (SCI, defined as the CRMS divided by the mean of observed values). Wave set-up occurs only in the surf zones to establish the primary momentum balance between cross-shore breaker momentum acceleration (the major component in the radiation stress divergence) and the pressure gradient force (Bowen et al., 1968). Storm surge statistics, obtained comparing the modelled and observed residual signal (total water level minus astronomical tide), of the two simulations (coupled vs. uncoupled) do not differ significantly. Thus, even if the model coupling is correctly implemented, in the present model version the discretization at the coast (about 1 km) is not enough to properly resolve this process, since generally the surf zone along the Italian coast is in the order of few hundreds meters even during storms except the coastal part of the Northern Adriatic Sea, characterized by a gentle slope.